Home
507.238.9051 507.238.9998 fax Email

Air Conditioning / Oil Heat Operation: Badger 1085AC

To operate the air conditioner/oil heater, use the following procedures:

A) Air Conditioning Mode:

  1. Start the machine and rotate the fan control to high, medium, or low speed.
  2. Set the master toggle switch to the a/c mode.
  3. Rotate the air conditioning thermostat to a desired setting. Rotating the thermostat clockwise will increase cooling.

B) Oil Heat Mode:

  1. Start the machine and rotate the fan control to high, medium, or low speed.
  2. Set the master toggle switch to the heat mode.
  3. Rotate the heat thermostat to a desired setting. Rotating the thermostat clockwise will increase heating.
  4. Increase the machine idle up to about 1000 rpm, or until there is adequate heat, and then return to low idle. If there is not adequate heating at low idle, increase the engine rpm until adequate heat is achieved.

Note: The typical air conditioning system refrigerant charge is about 2 lbs. of R-134a refrigerant and 5.5 oz. of PAG oil (SP20). 

Manual: